Pages

Pages

Sunday, November 8, 2015

Things that don't work.

Sitting in the bus today, I reflected on things that haven't worked out. Not because of the waste of time and money but because things that haven't worked out have been minimal.
1. My cheap 10-24 bolts that broke under very light pressure.
2. My plan for barrels as water tanks. They're just not available!
3. My multimeter. I bought a multimeter in around 2006 and tried it today. It's totally dead. I tried changing the battery and the internal fuse but it is dead, refusing to move the needle even after twiddling all the adjustments. Yet another gizmo designed not to last very long and another reason not to buy expensive gizmos.

4. Rustoleum paint. This doesn't stick to anything.
5. Silicone sealant. This works well but doesn't stick to PVC. By the time I realised that, I'd already laid my PVC floors. Had I known this before, I'd have used latex sealant instead as that does stick to PVC. That would have meant I would not have needed a shower base. As for the roof, the silicone sealant works but doesn't lie flat. That could be a problem if a tree branch rubbed the raised seal off.
6. Latex paint. This looks good and adheres well. It's just not that rugged.
7. Interior. Were I doing this again, I'd probably do it very differently. I did it the way I have because I was aiming at an all electric installation. I think I'd put less woodwork inside and I'd put a pot bellied stove to compensate in colder weather. I've designed my installation as more of a home for extended periods. I'd probably have been better keeping it more like a weekend camper.
8. It looks like some of my NiCad batteries haven't survived. I tried charging them today.

9. My microwave. Sure it didn't cost much but it should have lasted longer than a mere 2 years. I used it daily from November of 2011 to April of 2015. By mid 2013 the paint was bubbling and peeling. I wouldn't use that microwave now. It's just in too poor condition.

10. Electromagnets - I'd just make my own rather than fiddling about waiting for them to come from China.

As far as I've gone, I'm happy. I need to thin out my stuff - I have too many clothes so I need to get shot of stuff that no longer fits. I might need to thin down on books to - perhaps go for ebooks instead? I've also got a pile of broken mobile phones, old chargers and general electronic wiring garbage - the kind you build up on all the time. I probably need to cut down in crockery too. I have a set of cheap mainstays China that cost me a princely $10.

Since my microwave has clearly died, I'm wondering whether I should go for something like a small gas burner and put an extraction fan in. That would increase water usage as I'd have to do more washing of saucepans but would decrease the need for electricity. That would put me squarely into boondocking territory. Having viewed the prices though, a replacement microwave seems better as well as safer.

Going forward the plan is - given a dry weekend - to redo all the bolts in my underbody compartment. This weekend was a loss because of the rain. There are a lot of dry weekend tasks to be completed, if ever there is another dry weekend. There seems to be somewhat of a plot against me these days as every weekend is wet. I blame the French! Only the French can be underhanded enough to inflict me with wet weekends.

Sealing or rather resealing the roof seams and repainting will all have to be done in due course. I'd love to have done more over the summer but what with heat exhaustion, it was rather hard. It'd be nice to be able to work under cover but building even the cheapest cover over my bus would be prohibitively expensive.

This weekend, nothing much was achieved bar a redesign of the plumbing necessitated by availability of supplies. With luck, next weekend will be better.

I'll have to do something about onboard humidity. 78% is high. Maybe I should get a Peltier dehumidifier and try to run it from a solar panel? If that works, it bodes well for a Peltier fridge.

No comments:

Post a Comment