Out of interest, I had another look at the bus conversion forum online. Yup... They're still mostly plonkers. I put a simple question about paint and had answers from the outlandish to the ridiculous. Not one could name a barrier primer nor the best value economy top coat yet they all claim to have busses and all claim to have repainted them!
Today I visited Tractor Supply. I didn't buy much. In fact I spent less than $10 but in addition to 100 10-24 nuts and two M4 bolts. I got some 1\4x20 bolts, nuts and lock nuts. Thinking about it, I'd probably have been better off buying all my nuts and bolts from Tractor Supply as they sell them by the pound!
The 1\4x20 bolts will carry way in excess of 1200lbs before sheering. Again, looking for the sheer strength online produced very dubious looking figures. My usual go-to source of The Handbook of Chemistry and Physics didn't have anything bar a definition of sheer strength. Perhaps my engineering handbook would but at the moment it cannot be located.
The 4mm bolt did the biz. This screws into my electro magnet nicely. The bolt is a shade too long but I can always space it off with washers or even trim the bolt a shade with my angle grinder. All I need is to bolt one to a steel bracket and the other to the underside of the latch and the bracket to the bulkhead beneath the latch and its a very simple electro unlocking mechanism. They always say to keep it simple!
If the dual electro magnet affair works as hoped then it would be possible to add remote unlocking. Remote locking could be more challenging, however.
Thinking about a pull on the front door to close it, I realised that as I have a penchant for large size keyrings, I could put a small hook on the outside of the door and use my keyring to pull it shut. Thus I would also be more certain of not locking my keys in the bus!
Today I visited Tractor Supply. I didn't buy much. In fact I spent less than $10 but in addition to 100 10-24 nuts and two M4 bolts. I got some 1\4x20 bolts, nuts and lock nuts. Thinking about it, I'd probably have been better off buying all my nuts and bolts from Tractor Supply as they sell them by the pound!
The 1\4x20 bolts will carry way in excess of 1200lbs before sheering. Again, looking for the sheer strength online produced very dubious looking figures. My usual go-to source of The Handbook of Chemistry and Physics didn't have anything bar a definition of sheer strength. Perhaps my engineering handbook would but at the moment it cannot be located.
The 4mm bolt did the biz. This screws into my electro magnet nicely. The bolt is a shade too long but I can always space it off with washers or even trim the bolt a shade with my angle grinder. All I need is to bolt one to a steel bracket and the other to the underside of the latch and the bracket to the bulkhead beneath the latch and its a very simple electro unlocking mechanism. They always say to keep it simple!
If the dual electro magnet affair works as hoped then it would be possible to add remote unlocking. Remote locking could be more challenging, however.
Thinking about a pull on the front door to close it, I realised that as I have a penchant for large size keyrings, I could put a small hook on the outside of the door and use my keyring to pull it shut. Thus I would also be more certain of not locking my keys in the bus!
No comments:
Post a Comment